The emission characteristics of a petrol–ethanol–diethyl-ether blend as a carbon monoxide reduction additive in spark ignition engine

The emission characteristics of a petrol–ethanol–diethyl-ether blend as a carbon monoxide reduction additive in a spark ignition (SI) engine is presented. The experimental set-up is consisting of a Villiers G200, 6.5?hp, 4-stroke; single cylinder SI engine. The blend used was synthesised using petrol, ethanol and diethyl ether in the following percentage proportion by volume as 75:15:10, 60:25:15, 80:15:5, 85:10:5, respectively. These blends were tested at full engine load and at an operational speed of 2500?rpm. Exhaust emission probe was inserted at the exhaust pipe in order to determine the emission characteristics of these blends under different operating conditions. The results obtained during the emission test carried out show that CO emission level of petrol is higher than that of any of the blends with the 60:25:15 blends having the least emission level. The lowest CO emission of the blend is due to the high oxygen content of fuel blend. The above result shows a great promise in the fight against carbon oxide emission.     

A Voltage Control Method for a Distributed Line Feeder by means of Multiagent Approach

This paper proposes a method for the coordinated control of power factor by means of a multiagent approach. The proposed multiagent system consists of two types of agent: single feeder agent (F_AG) and bus agent (B_AG). In the proposed system, an F_AG plays as an important role, which decides the power factors of all distributed generators by executing the load flow calculations repeatedly. The voltage control strategies are implemented as the class definition of Java into the system. In order to verify the performance of the proposed method, it has been applied to a typical distribution model system. The simulation results show that the system is able to control very violent fluctuation of the demands and the photovoltaic (PV) generations.     

Estimation of power density in IMPATT using different materials

ABSTRACT

The RF output power dissipated per unit area is calculated using Runge-Kutta method for the high-moderate-moderate-high (n⁺-n-p-p⁺) doping profile of double drift region (DDR)-based impact avalanche transit time (IMPATT) diode by taking different substrate at Ka band. Those substrates are silicon, gallium arsenide, germanium, wurtzite gallium nitride, indium phosphide and 4H-silicon carbide. A comparative study regarding power dissipation ability by the IMPATT using different material is being presented thereby modelling the DDR IMPATT diode in a one-dimensional structure. The IMPATT based on 4H-SiC element has highest power density in the order of 10¹⁰ Wm^?2 and the Si-based counterpart has lowest power density of order 10⁶ Wm^?2 throughout the Ka band. So, 4H-SiC-based IMPATT should be preferable over others for the power density preference based application. This result will be helpful to estimate the power density of the IMPATT for any doping profile and to select the proper element for the optimum design of the IMPATT as far as power density is concerned in the Ka band. Also, we have focused on variation of power density with different junction temperatures and modelled the heat sink with analysis of thermal resistances.     

小型煤矿低浓度瓦斯发电技术及应用效果研究

针对云南富源县辖区内大量小型煤矿抽采的低浓度瓦斯未开展有效利用的问题，以区内某小型煤矿为背景，采用现场调研、分析归纳、理论计算相结合的方法对其低浓度瓦斯发电项目展开分析研究。研究表明，某小型煤矿低浓度瓦斯发电项目成功的关键是“瓦斯治理先行”理念主导下的气源保障综合技术体系。在气源得以保障的基础上，该小型煤矿低浓度瓦斯发电项目已经持续高效运行4年，每年创造经济收益约403.2万元，减排CO2约4.47万t；同时促进了煤矿瓦斯治理工作有效落实，提高了煤矿安全生产水平，保障了煤矿产量的达标。     

Heat Transfer Analysis of MHD Power Law Nano Fluid Flow through Annular Sector Duct

Flow and heat transfer analysis of an electrically conducting MHD power law nano fluid is carried out through annular sector duct,under the influence of constant pressure gradient.Two types of nano particles(i.e.Cu and TiO2)are used in power law nano fluid.Strongly implicit procedure,(SIP)is used to simulate the discretized coupled algebraic equations.It has been observed that volume fraction of nano particles,ϕand magnetic field parameter,Ha are favourable for the heat transfer rate,however,both resist the fluid flow.Impact of applied uniform transverse magnetic field exceeds in the case of shear thickening fluids(i.e.n>1)by increasing the value of Ha as compared to that in shear thinning fluids(i.e.n<1).Therefore,enhancement in heat transfer rate is comparably more in shear thickening fluid.Furthermore,comparable limiting case study with published result is also carried out in this research paper.     

基于峰谷分时电价的虚拟电厂日前申报及运行优化

鉴于分布式能源的出力性质为间歇性和波动性,影响电网安全高效运行,而虚拟电厂可解决此问题。对虚拟电厂进行申报-调度两阶段建模,以包含分布式电源(光电、风电和燃气轮机)和储能系统(储能电池)两大类分布式能源的虚拟电厂为例,基于光照强度及风速等不确定因素,研究峰谷分时电价下日前市场虚拟电厂的出力申报和运行调度策略并利用风险价值模型进行风险管理。结果表明,申报出力时,当电价激励足够高时储能电池方会参与出力,成功起到削峰填谷的作用;运行调度时,平衡出力偏差方面,储能电池发挥主要作用,且虚拟电厂运行调度策略具有一定的经济效益。     

基于电锅炉的火电机组灵活性改造技术研究

为有效解决东北电力产能过剩,促进风电、核电等清洁能源消纳问题,提升燃煤供热机组的灵活性,针对东北地区某热电厂,通过对热电解耦时间、电锅炉型式以及不同电锅炉容量配置对机组实际发电负荷的影响等灵活性改造关键技术进行研究,确定了最佳电锅炉容量,提出了电锅炉装设方案,并对改造前后机组的调峰能力和性能指标进行对比分析。研究表明:随着电锅炉容量增长,抵减电锅炉用电后机组实际发电负荷率显著降低,提升火电机组灵活性改造后,电厂调峰能力显著提升,考虑以全厂172 MW发电负荷运行,电厂调峰能力在采暖初末期增加了368 MW,采暖中期增加了528 MW;全厂供热标煤耗由39.7 kg/GJ降低至34.3 kg/GJ,降低了5.4 kg/GJ;经济效益显著,扣除电锅炉用电成本后1个采暖季的调峰辅助服务补贴收益为1.47亿元;同时,电锅炉投运后可实现电厂的上网电量接近零,为清洁能源就地消纳做出贡献。     

基于流数据聚类算法的电力大数据异常检测

针对电力大数据流的异常检测问题,该文将流数据聚类算法与电力大数据相结合,针对现有流数据聚类算法不易存储全部数据、断电数据易丢失等问题,以及流数据聚类算法对于离线阶段聚类算法实时应答的要求,从数据的完整性、安全性以及流数据聚类算法的低时间复杂度的角度出发,对CluStream流数据聚类算法进行改进,提出流式K-means聚类算法。对在线阶段,使用Redis集群进行流数据的缓冲,并设计节点时间衰减策略,增大心跳消息中有效消息所占比例;对离线阶段聚类算法进行优化,使用最佳距离法确定初始聚类中心,减少迭代次数;最后,使用所提出的流式K-means聚类算法进行用户用电异常行为检测,实验结果表明,该算法能够很好的发现用户用电异常行为。     

Potential of performance improvement of concentrated solar power plants by optimizing the parabolic trough receiver

This paper proposes a comprehensive thermodynamic and economic model to predict and compare the performance of concentrated solar power plants with traditional and novel receivers with different configurations involving operating temperatures and locations. The simulation results reveal that power plants with novel receivers exhibit a superior thermodynamic and economic performance compared with traditional receivers. The annual electricity productions of power plants with novel receivers in Phoenix, Sevilla, and Tuotuohe are 8.5%, 10.5%, and 14.4% higher than those with traditional receivers at the outlet temperature of 550°C. The levelized cost of electricity of power plants with double-selective-coated receivers can be decreased by 6.9%, 8.5%, and 11.6%. In Phoenix, the optimal operating temperature of the power plants is improved from 500°C to 560°C by employing a novel receiver. Furthermore, the sensitivity analysis of the receiver heat loss, solar absorption, and freeze protection temperature is also conducted to analyze the general rule of influence of the receiver performance on power plants performance. Solar absorption has a positive contribution to annual electricity productions, whereas heat loss and freeze protection temperature have a negative effect on electricity outputs. The results indicate that the novel receiver coupled with low melting temperature molten salt is the best configuration for improving the overall performance of the power plants.     

分散式风电多点接入协调优化控制策略

针对分散式风电机组并网导致的配电网网损增加、电压稳定性降低等问题,文章提出一种分散式风电并网多点协调双层控制策略。首先,分析了分散式风电多点接入特性,研究分散式风电多点接入后的网损、电压分布和功率因数的关系,并提出最小网损和电压偏差为目标的双层优化控制策略。最后,基于IEEE-33节点进行仿真计算,结果表明,所提多点协调控制策略能够有效降低配电网网损和提升母线电压水平,增加系统的稳定性。与超前功率因数相比,滞后的功率因数能够增大风能消纳能力,提高供电可靠性,减少电压偏移水平。